Windows Accelerator Installation

This section will assist you with the installation of the Web Accelerator for the Windows.

1. Minimum System Requirements

Pentium 200MHz 64MB RAM 5MB of hard-drive space Windows 95b with Winsock 2, Windows 98, Windows 98SE, Windows Millennium Edition (Windows ME), Windows NT 4.0 Service Pack 6, Windows 2000 and Windows XP Internet Explorer 5.0 or Netscape 6.0 as well as any later

2. Download

Click here to download the Accelerator. Download the installer to your desktop.

3. Install.

After downloading the SlipStream Web Accelerator installer onto your Desktop, an icon as shown below will be on your Desktop. Double-clicking on the icon will launch the installer.

The installer will guide you through the complete setup process.

4. Connect.

As this is your first time launching the product, you will be prompted for a username and password. Enter the username and password provided by Internet Connect in the fields provided.

Click OK. Web Accelerator will connect to Internet Connect. After installing the Web Accelerator, an icon as shown below is placed in your system tray. Acceleration will take place immediately after any web browser launches.

4. Browse.

Browse the web as you normally would. The Web Accelerator will automatically accelerate your browsing session. When finished, simply close your web browser, as you normally would, and SlipStream Web Accelerator will remain idle in your system tray. If you want to stop the application after browsing, select Stop SlipStream from the pop-up menu. If you desire to exit the application completely, click Exit from the pop-up menu. The pop-up menu can be accessed by clicking on the icon located in the system tray.